Flowmaster 15398 4.00' Polished Stainless Steel Angle Cut Clamp-On Exhaust Tip for 3.00' Tubing

3 Customer reviews

Sale
$ 44 72
+


Product Description

  • Wide variety of shapes and sizes
  • Premium quality
  • Highly polished finish
  • Clamp-on design

539 4.00" Polished Stainless Steel Angle Cut Clamp-On Exhaust Tip for 3.00" Tubing


Customer reviews(3)

Write Review
cj
May 7, 2014
Sturdy stainless construction, fair finish. The double wall is open at the clamp end keeping the outer wall cooler which is what I wanted.

I wish the clamp was heavier but in my RV setup (heat shield u bolted to existing pipe and this pipe) it should hold. Welding is an option.
It was tough to get this pipe on over existing 3" id exhaust pipe. Had to slot the existing pipe an inch to get it started and drive on with a hammer and a block of wood. It did seat all the way on. No change in exhaust sound noted.
Kevin c Williams
September 24, 2014
Gives your exhaust a great clean, finished look. Had a Gibson before but the flowmaster looks better, heartier.
KO Jim
February 9, 2016
Turned yellow almost immediately. If you can make sure the Flowmaster tip slides on the exhaust pipe the entire length of the Flowmaster tip the yellowing may be avoided. On my vehicle the exhaust pipe only came half way to the end of the Flowmaster and that is where the yellowing starts from the heat of the exhaust.


Back to top